After-sales and supply
Spare parts, replacement batteries and warranty claims
Solar lighting is a product with consumable components, and a buyer who installs
several hundred units eventually needs replacement parts rather than whole luminaires.
The question that comes up most often is simple: can the battery, the driver and the
LED module be supplied on their own, and how does a warranty claim actually get
processed? This page sets out how Minglong handles it, and what information to send so
the answer can be specific rather than general.
What can be supplied separately
The three components buyers actually replace
A solar luminaire has three parts that wear out or are damaged in the field, and
they are treated differently because they are specified differently.
BatteryThe component most often replaced. The catalogue
battery is LiFePO4 (lithium iron phosphate), and the listed capacity is shown per
catalogue grade on each model page — from 2AH up to 35AH across the range. A
replacement has to match the voltage and the case format of the grade installed,
which is why the original model and catalogue grade are needed. Send the model, the
grade and the existing battery marking.
LED moduleThe LED board and its driver are the parts
that determine the light output rather than the energy storage. The catalogue lists
the LED quantity for each grade — for example 36*6 for one listed configuration — and
the LED chip type used across the range is 2835. A replacement module is matched on
the model, the grade and the listed LED quantity.
Controller and other board-level partsMatched on the
model and the operating mode. The operating mode listed per model — light control,
radar sensing, remote control or a combination — is part of the match, because the
controller has to work with it.
Structural partsHousing, bracket and pole interface
are matched on the model and on the mounting arrangement at the site. Send a
photograph and the installation height if the part is a physical fit rather than an
electrical one.