Specification guide
What the IP rating on a solar street light actually tells you
The IP rating is the one line in a solar street light specification that is easy to
copy from another datasheet without checking whether it matches the site. This page
explains what each rating covers, which rating different outdoor sites normally need,
and how to make sure the rating on the model you order is the rating you actually
need. The catalogue figures quoted here come from the Minglong factory PDF catalogues.
Matching rating to site
Which rating your project usually needs
The rating should follow the exposure of the installation position, not the
reputation of the supplier. The position of the unit — pole, wall, bracket, ground
level — decides the exposure.
Open road or village poleIP65 is the normal
specification. The unit is exposed to rain from all directions but is not in a
wash-down or immersion position.
Compound wall or building perimeterIP65 normally
suffices where the light is above splash height. Where the unit is mounted low or
the wall is washed down, a higher second digit becomes worth specifying.
Warehouse, farm building or yardWhere units sit close
to water outlets, vehicle wash areas or open industrial dust, IP66 gives the
additional jet protection. The exposure, not the location, is the deciding
factor.
Low ground level or flood-prone positionWhere the unit
can be stood in or washed over by standing water, IP67 adds temporary immersion
protection. Confirm whether the specific model carries it.
Coastal and corrosive positionsSalt spray is a
material and coating question as much as an ingress question. Send the site
condition in the enquiry so the quotation can confirm what applies to the selected
model.
Inside the model pagesEach Minglong model page lists the
rating for that model in its specification table. Check the specific model, not
the family. Model parameter library.